OFFICIAL TECHNICAL REFERENCE
Minoston MT13N User Guide & Tech Specs
30-Minute Countdown Timer Switch Complete Reference
QUICK JUMP:
30-SECOND SUMMARY
Quick overview of hardware design, presets, and electrical capability.
The MT13N is a wall countdown timer with six presets from 1 to 30 minutes, matching how long a bathroom fan actually needs to run. 960 W incandescent, 1800 W resistive or a 1/2 HP motor. A neutral wire is required. 120 VAC 60 Hz, FCC.
TECHNICAL SPECIFICATIONS
Core electrical ratings, RF frequency, and hardware capabilities.
WIRELESS PROTOCOL
Standalone Hardware (No Wi-Fi / Radio)
INPUT VOLTAGE
120V AC, 60Hz
WIRING REQUIREMENT
Neutral Wire Required (Single Pole Only)
SAFETY CERTIFICATIONS
ETL Listed · FCC Part 15B
APPLICABLE ELECTRICAL LOAD TYPES
Supported electrical loads, outdoor equipment, and lighting ratings.
15A / 1800W
Resistive
General resistive loads, space heaters, and basic appliances
1200W
Tungsten
Tungsten halogen lighting fixtures and heat lamps
960W
Incandescent
Standard residential incandescent lighting circuits
1/2 HP
Motor
Bathroom ventilation exhaust fans (ON/OFF only, no speed control)
Physical Installation & Safety
01
Step 1: Choose the Right Location
Choose a suitable wall box and make sure the installation area is clear of obstructions and meets the product’s installation requirements.
02
Step 2: Secure the Switch
Turn off the circuit breaker, verify the power is off, and securely connect the wires according to the wiring diagram. Mount the switch in the wall box.
03
Step 3: Connect the Load
Connect the load wire to the appropriate terminal. Make sure the connected device is within the switch’s rated load limits.
04
Step 4: Restore Power and Test
Turn the circuit breaker back on and test the switch manually to confirm it turns the connected device on and off properly.
HARDWARE SETTINGS & BUTTON OPERATIONS
Hardware settings, dial positions, and timing presets.
| Setting / Option | Mode / Type | Values & Description |
|---|---|---|
| Adjust LED Indicator Brightness | Hardware Setting | Hold the 20 Min(dim) or 30 Min(brighten) button for 3 seconds. |
| Manual ON/OFF Override | Hold the ON/OFF button until the indicator flashes. |
Button Operations & LED Indicators
| Status / Indicator | Description / Physical Feedback |
|---|---|
| Amber LED Flashes Rapidly | Successful setup |
| Preset LED Lits | Selected countdown time |
| Buttons lit | powered |
Troubleshooting FAQs
Direct solutions to common network, protocol, and pairing questions.
Q: Will it fit my bathroom?
A: Mechanically yes, it is a standard single-gang Decora-style switch. The constraint is the neutral wire, not the fit. If your old switch has only two black wires and no white bundle, this timer cannot be powered.
Q: A screw broke during installation.
A: The terminals are small and the screws are soft; over-torquing shears them. Use a correctly sized flat-head driver and stop when the conductor is snug. A broken screw cannot be repaired, exchange the unit.
Q: Can it control a light and a fan together?
A: Only if the combined load stays under 960W incandescent and both are on the same switched leg. Separate legs need two timers.
Manuals & Technical Downloads
Official PDF documentation and engineering resources for Minoston MT13N:
Minoston MT13N Official User Manual
Model: MT13N · Installation & Parameter Specs